Tie Pilot WIP

[vader2nd]

Hello,

To any Tie Pilots out there.  I'm in the beginning stages of the build.  Any assistance with some issues that need to be addressed before it's too late would be greatly appreciated.  I have already been informed about the rectangle on the mohawk.  FYI I am going for original trilogy style.  I have also not applied any of the detail pieces to the helmet or the armor.  Thank you in advance for any help.

[Backpacks Got Jets]

with 3D Printed parts just make sure your finishing routine is very good because print lines will show up very glaringly on a gloss piece and they'll keep you from getting  approved

 

The best advice i can give since im not a tie pilot is as you work on each piece make sure that that part is meeting the CRL.  Dont wait until you're done with the build to start comparing them

 

https://crls.501st.com/jrs/tie-pilot-original-trilogy

 

Have you started a build thread on the JRS Detachment boards?

[vader2nd]

22 hours ago, Backpacks Got Jets said:

with 3D Printed parts just make sure your finishing routine is very good because print lines will show up very glaringly on a gloss piece and they'll keep you from getting  approved

 

The best advice i can give since im not a tie pilot is as you work on each piece make sure that that part is meeting the CRL.  Dont wait until you're done with the build to start comparing them

 

https://crls.501st.com/jrs/tie-pilot-original-trilogy

 

Have you started a build thread on the JRS Detachment boards?

Yes, I've done that already got some feedback on the helmet, and I'm in the process of fixing that.

[Backpacks Got Jets]

excellent im looking forward to see your progress!